The Sloping Plate
Pultdach mit steigender Pfette
In the book
Das neue Buch vom alten Wissen der Schiftung
The new book on the ancient knowledge Schiftung
The new book on the ancient knowledge Roof Framing
by Bernd Küppers
This sentences needs some work or a drawing that shows the process clearly.
________________________________________________________
Because the inclined rafter with edge bevel is canted in the plane profile,
the heel and bevel seat must be determined. To do this, connect the BE of the oblique rafter by eaves height with the top and bottom edges of the rafter.
From the intersection of BE inclined rafter at
EH and TE rafter at EH G (eave line) TS = top seat is formed, parallel to the surface
edge.
The point of intersection of BE inclined rafter
at EH and BE rafter at EH G in the
ground, must first be folded, at right angles to the rotation axis, to the BE rafter at EH P (P
= plane) which runs parallel to the surface edge. => BS = bottom seat
Draw a perpendicular line from BE rafter at EH G and outer edge of the oblique rafter in Ground Plan to BE rafter at EH P. The intersection of these two lines defines the point for a parallel line from the outer edge of the oblique rafter on the roof surface plane.
The new book on the ancient knowledge Roof Framing by Bernd Küppers
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.